0
$0.00
0
Manual For Voron V0 Kit (2020.10.10-2020.10.17)

Attention:

The manual here only for this batch Voron V0 kit  (order between at 2020.10.10-2020.10.17), Thanks for your trust.

First:

When the package arrived, please check all things,

if something missing, please contact with me at the first time, both Aliexpress / Discord / Email are OK.

For some packages, Meanwell PSU is in the Buildplate box

You will found extra BMG gears in the BMG box, it’s high-quality ones since we made a mistake for normal BMG extruder

 

 

For building it , you need some tools/parts,

Including but not limited to:

1.Inner hexagon spanner (From 0.8-5mm)

2.Electric iron

3.Crimping pliers

4.Some terminal block (Needle and fork)

5.Cross screwdriver

6.Nylon Tie

Second:

Check whether the aluminum extrusionss, build plate and MGN7H rails are in good condition

If there’s any problem, please contact us at first .

Third:

Check electronic products, (Raspberry 3B+, Skir mini e3, Meanwell 24V 100W, DC-DC)

Fourth:

About Heater Bed:

The thick two wires are power wires

The thin two wires are the NTC 100K wires

Don’t get them wrong!

 

About SSR:

There are 3 pins on SSR (DC+,DC-,CH1), Follow this pic .

Yello => CH1

White => DC-

Red => DC+

 

Notice For SKR 2.0 from @lovesegfault:

use pin PC15 instead of PC12 (wire to CH1), wire DC+ to 5V, DC- to GND, and set !PC15 in make menuconfig

 

 

Other:

 

 

  1. If it’s hard to pass kfl08 through the lead screw, try to use sandpaper
  2. There’a C14 Inlet with fuse inside in the kit, the fuse is 2A/250V,

There are some small imperfections in the packages:

  1. No MircoFit/SM connectors in kit, V0 is small enough, I havn’t use them in mine.
  2. Maybe you need a Braided tube to manage wire

If you meet any trouble , please contact me .

your confirm receieved can help me much !  Thanks .

Leave a Reply

Your email address will not be published. Required fields are marked *

X
Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.