Attention:

The manual here only for this batch Voron V0 kit  (order between at 2020.8.10-2020.8.15), Thanks for your trust.

First:

There is a list in the package. (I missed it for a few packages… sorry )

When the package arrived, please check the list for all things, if something missing,

please contact with me at the first time, both Aliexpress / Discord / Email are OK.

magnet is in BMG box, SD card is in SKR MINI box.

 

For building it , you need some tools/parts,

Including but not limited to：

1.Inner hexagon spanner (From 0.8-5mm)

2.Electric iron

3.Crimping pliers

4.Some terminal block (Needle and fork)

5.Cross screwdriver

6.Nylon Tie

Second:

Check whether the aluminum profile , build plate and MGN9H rail are in good condition

There may be some wear on the surface of aluminum profile during shipping.

If there’s any problem, please contact us at first .

Third:

Check electronic products, (Raspberry 3B+, Skir mini e3, Meanwell 24V 100W, DC-DC)

Fourth:

About Heater Bed:

The thick two wires are power wires

The thin two wires are the NTC 100K wires

Don’t get them wrong!

 

About SSR:

There are 3 pins on SSR (DC+,DC-,CH1), Follow this pic .

Yello => CH1

White => DC-

Red => DC+

 

Other:

 

 

1. If it’s hard to pass kfl08 through the lead screw, try to use sandpaper
2. There’a C14 Inlet with fuse inside in the kit, the fuse is 2A/250V,

There are some small imperfections in the packages:

1. No MircoFit/SM connectors in kit, V0 is small enough, I havn’t use them in mine.
2. Maybe you need a Braided tube to manage wire

If you meet any trouble , please contact me .